Car Fault Trouble-shooting Forum / Audi / Audi problems

Faulty Level Control

anyware — Mon, 17 Jan 2011 12:54:28 GMT

Dears:

I have Porsche Cayenne 2005. The car tends towards left side. An error code 1772 - Signal lead for pressure sensor- appears on Porsche Diagnostic.

Does this mean a faulty pressure sensor?

If yes; please inform me where is, this sensor, located?

If not; how can I fix the problem?

I am sorry that I am posting Porsche in audi Forum. However, I could not make a new post at Porsche Forum.

Kind Regards,

AnyWare

a4 power problem

zephyrmate — Sat, 30 Jan 2010 21:32:12 GMT

i have an audi a4 1.9 tdi which cuts into limp mode under load or hard acceleration would be grateful for any information thanks

Audi

paranoid — Wed, 23 Dec 2009 19:00:05 GMT

AudiA6 18t Avant misfiring and smoking. can any one help

under bonnet cooling

vincent — Tue, 19 May 2009 03:39:19 GMT

Hi guys, new here, my question is, i read on a website that putting air vents in a cars bonnet helps hot air escape from under the bonnet and allowing cooler air in thus been kinder to the engine and maybe helping the engine perform a bit better, any opinions welcome please.

bye

vincent

Electrical Fault?

seanius — Fri, 03 Apr 2009 16:20:01 GMT

Hi,

I have just bought and Audi A4 Avant 05 Plate 2.0 TDI.

The car was fine when I drove it home. When I went to start it up again the car had no power at all. I soon discovered that the negative terminal on the battery was not secured properly so I reconnected and tightened it and it all appeared to be fine.

Until the day after, my wife stalled the car by accident after which the head lights remained on (even with the key out of the ignition) and none of the indicators or windscreen wipers would work!

I disconnected the battery thinking it may be a 'computer' problem however it did not fix the problem. After a short while having the engine running I decided to take the car home. The minute I moved away the indicators sprang back into life!

Can anyone advise me what is going on - is there a loose connection somewhere?

Thanks in advance.

S

seat toledo

peter — Sun, 28 Dec 2008 16:03:44 GMT

my seat toledo 2000 1.6 petrol. engine stops after start up from cold, when slowing up to junctions and slowing down for corners. ive replaced the lambda sensor, problem seems better but fault still there

Clutch problem

nannyhelen — Wed, 05 Nov 2008 23:01:32 GMT

My son has put a new clutch and new slave cylinder in my R reg Audi A4. He has bled the clutch and there is no air coming out but still the clutch isn't disengaging. Can anyone help please. My son is a fully qualified mechanic but this has got him really stumped.

Many thanks

Helen